 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
In addition to marking and cutting wire, the microprocessor- controlled Model 67610 also strips wire to length. |
ERROR MESSAGES - Error or fault messages are displayed on the control panel to indicate the following conditions:
 |
Lack of compressed air (safety shield raised or compressor off) |
|
Insulation damage (spark tester) |
|
End of foil |
When a fault occurs, the machine will not operate until the condition is corrected. If there is a wire jam in the optional prefeed, the prefeed sounds an alarm buzzer and disables the wire marker until the jam is cleared.
FOUR MODELS AVAILABLE - Microprocessor-controlled wire markers are available in the following configurations:
| Model 67610 - Mark, cut and strip, with spark tester. Model 67605 - Mark, cut and strip, without spark tester. Model 67510 - Mark, cut to length, with spark tester. Model 67505 - Mark, cut to length, without spark tester. |
POWER REQUIREMENTS - Electrical - 115 VAC, 10A, 50/60 Hz or 230 VAC. 5A, 50/60 Hz. Compressed Air - 80- 100 psi (5.5- 7.0kg/cm2), minimum of 1/2" I.D. (12.7mm) air line. Uses approximately 20cfm (0.5 cubic meter/min) when cutting short lengths or marking at close intervals.
WEIGHT - Shipping Weight: Approximately 310lbs. (140kg).
DIMENSIONS - With spark tester - 23"H x 29"W x 26"D (584 x 736 x 660mm).
Without spark tester - 16 1/2"H x 29"W x 24"D (419 x 736 x 609mm).
<< Return to previous page | Page 2 of 2