Model 6815-07/08 flat cable prefeed

Designed to feed both flat ribbon cable and products such as heat shrink tubing, the Model 6815-07/08 Flat Cable Prefeed is the ideal partner for the Model 4600 Flat Cable and Tubing Cutter.

Model 6815-07/08
Flat Cable Prefeed

It uses the same proven demand mechanism as the other 6800 Series prefeeds. It also incorporates the same mechanism that automatically stops the prefeed in the event of a cable tangle or jam. And it is very simple to load and unload. After placing the spool on the spindle, a spring-loaded manual lever is used to open the feed roller drive mechanism, the cable is loaded between the feed rollers, and the cable is passed through the lower and upper pulleys. A jog switch is used to feed the cable forward and backwards during loading and unloading. A 1/2 HP motor will maintain a 30-lbs. direct pulling force on the cable at a continuous feed speed of 94 inches per second.

Model 6815-07/08 Specifications

Power Requirements
6815-07: 115 VAC +/-5%, 60 Hz +/-2 Hz, 10 A
6815-08: 230 VAC +/- 5%, 50 Hz +/-2 Hz 6 A

Height: 40 in. (1016 mm)
Length: 24 in. (610 mm)
Width: 18 in. (457 mm)
Weight (without wire spool): 81 lbs. (37 kg)

Shipping Weight: 110 lbs. (50 kg)
Drive Mechanism: 2 feed rollers
Maximum Drive Speed: 4 in/sec. (2.3 rn/sec.)

Wire Spool Specifications

Max. Spool Diameter: 16 in. (400 mm)
Max. Spool Width: 10 in. (254 mm)
Max. Spool Weight: 75 lbs. (34 kg)
Min. Center Hole Diameter: 0.75 in. (19 mm) Max. Ribbon Cable Width: 3.2 in. (81 mm)
Min Ribbon Cable Width: 0.030 in. (0.8 mm)
Max. Diameter for Tubing: 0.48 in. (12 mm)